66th Annual Meeting of the APS Division of Plasma Physics
Monday–Friday, October 7–11, 2024;
Atlanta, Georgia
Session BO08: Low Temperature Plasmas, Engineering, Technology, and Applications
9:30 AM–12:18 PM,
Monday, October 7, 2024
Hyatt Regency
Room: The Learning Center (Fixed)
Chair: Eva Kostadinova, Auburn University
Abstract: BO08.00008 : Dielectric Barrier Discharges in CO2 and CH4 at Sub-Atmospheric Pressures*
10:54 AM–11:06 AM
Abstract
Presenter:
Riley A Yager
(PhD Student)
Authors:
Riley A Yager
(PhD Student)
Andrei Stanishevsky
(PI)
Riley Nick
(Undergraduate Researcher)
The following investigation is a study of low-pressure, non-thermal plasma catalysis of greenhouse gases (GHGs), particularly CO2 and CH4, into high-value products. Non-thermal plasmas (NTPs), with mean energy of 1-10 eV, have potential to activate and dissociate ground-state gas molecules and allow reactions to occur at relatively low temperatures and atmospheric pressure. NTPs have shown to break the chemical bonds of the CO2 and CH4 molecules without the presence of a catalyst; however, the selectivity of desired products is poor due to unselective collisions between the active species. Dielectric Barrier Discharge (DBD) plasma of these gases at atmospheric pressures has been widely studied for the mitigation of waste; however, little to no literature is available on the behavior of these DBD plasmas at sub-atmospheric conditions. Preliminary data has shown that these processes at sub-atmospheric pressures are more efficient and require significantly less energy consumption to convert inert gases. Various designs of plasma reactors, which were based on DBD, have been designed to test their ability to operate efficiently low temperatures. All tested reactors had very low fabrication cost and simplicity in design. All prototype DBD reactors have been operated at pressures below 200 Torr. They have been investigated utilizing CO2 and CH4 gases at different flow rates and ratios of gas components. Plasma drivers used in this study included a nanosecond pulsed power source with square wave pulses up to 20 kV and operated at frequencies up to 10 kHz as well as a low frequency plasma driver for capacitive loads with voltages up to 40 kV at 300W power. The in-situ plasma species depending on pressure, frequency, and reactor configuration were analyzed using optical emission spectroscopy (OES). Downstream products were analyzed using Fourier transform infrared spectroscopy (FTIR) and gas chromatography (GC), equipped with flame ionization detection (FID), thermal conductivity detector (TCD), and mass spectrometer (MS).
*This work has been supported by the NASA Space Technologies Graduate Research Opportunities (NSTGRO) fellowship (Grant #: 80NSSC22K1171) and the Fulbright Poland fellowship program.