2006 48th Annual Meeting of the Division of Plasma Physics
Monday–Friday, October 30–November 3 2006;
Philadelphia, Pennsylvania
Session VI2: MHD
2:00 PM–5:00 PM,
Thursday, November 2, 2006
Philadelphia Marriott Downtown
Room: Grand Salon CDE
Chair: Darren Craig, Wheaton College
Abstract ID: BAPS.2006.DPP.VI2.1
Abstract: VI2.00001 : Active Resistive Wall Mode Stabilization in Low Rotation, High Beta NSTX Plasmas*
2:00 PM–2:30 PM
Preview Abstract
Abstract
Author:
S.A. Sabbagh
(Columbia University)
An active feedback system to stabilize the resistive wall mode
(RWM) in the
National Spherical Torus Experiment (NSTX) is used to maintain
plasma
stability for greater than 90 RWM growth times. These experiments
are the
first to demonstrate RWM active stabilization in high beta, low
aspect ratio
tokamak plasmas with toroidal plasma rotation significantly below
the
critical rotation profile for passive stability and in the range
predicted
for ITER. Actively stabilized, low rotation plasmas reached
normalized beta
of 5.6, and the ratio of normalized beta to the toroidal mode
number, n = 1
and 2 ideal no-wall stability limits reached 1.2 and 1.15
respectively,
determined by DCON stability analysis of the time-evolving
reconstructed
experimental equilibria. The significant, controlled reduction of
the plasma
rotation to less than one percent of the Alfven speed was
produced by
non-resonant magnetic braking by an applied n = 3 field. The
observed plasma
rotation damping is in quantitative agreement with neoclassical
toroidal
viscosity theory including trapped particle effects [1]. The active
stabilization system employs a mode control algorithm using RWM
sensor input
analyzed to distinguish the amplitude and phase of the n = 1
mode. During n
= 1 stabilization, the n = 2 mode amplitude increases and
surpasses the n =
1 amplitude, but the mode remains stable. By varying the system
gain, and
relative phase between the measured n = 1 RWM phase and the
applied control
field, both positive and negative feedback were demonstrated.
Contrary to
past experience in moderate aspect ratio tokamaks with poloidally
continuous
stabilizing structure, the RWM can become unstable in certain
cases by
deforming poloidally, an important consideration for feedback
system sensor
and control coil design in future devices such as ITER and KSTAR.
\newline
**In collaboration with R.E. Bell, J.E. Menard, D.A. Gates, A.C.
Sontag,
J.M. Bialek, B.P. LeBlanc, F.M. Levinton, K. Tritz, H. Yuh.
\newline
[1] W. Zhu, S.A. Sabbagh, R.E. Bell, et al., \textit{Phys. Rev.
Lett}. \textbf{96}, 225002 (2006).
*Work supported by U.S. DOE Contracts DE-FG02-99ER54524 and DE-AC02-76CH03073.
To cite this abstract, use the following reference: http://meetings.aps.org/link/BAPS.2006.DPP.VI2.1